Why can't the reinforcing glue be dried? Can the reinforcing glue be painted behind it?

When doing manicures, people will need to use a lot of products. Different manicure products have different functions. Reinforcing glue is used after nail polish. Generally, after using reinforcing glue, a sealing layer is needed to finish.

If the reinforcing glue doesn't dry, it may be because the exposure time is not enough. Generally, it takes 20 minutes for the reinforcing glue to dry. Reinforcing glue is not used by everyone who does nails. It is generally used for people with thin nails to increase the hardness and thickness of the nails.

Generally, it is applied after the base coat, not the color. The order of application is: base coat - reinforcement coat - color - seal coat. The specific method of use is: after applying the base coat, shine the light for 2 minutes, and then apply the color coat. If the nails are too thin, you need to increase the thickness. After increasing the thickness, you can avoid nail cracking. Applying it before the seal coat can protect the seal coat from scratches. Reinforce first and then seal. Apply the reinforcement coat before applying the sequins. After applying the sequins, apply two to three layers of reinforcement coat on top.

1. Disinfection.

2. Basic nail care, including nail trimming, hand soaking, nail cuticle trimming, and nail surface cleaning.

3. Use a sponge to polish the nail surface.

4. Use a dusting brush to clean the dust on the surface of the nails.

5. Apply desiccant and bonding agent on the surface of nails.

6. Apply base glue on the surface of nails and shine the light for about 30 seconds.

7. Apply the selected color glue in the same way as ordinary nail polish. Apply the four fingers except the thumb and put them into the light therapy lamp, then apply the thumb. Each time, light the lamp for about 2 minutes.

8. After taking it out, apply the second layer evenly to better reflect the color saturation. The lighting time is about 2 minutes.

9. Finally, apply the removable topcoat. Apply it thinly to make the nail surface smooth, so that the nails will look flat, not thick, and not bulky. Shine the light for about 3 minutes.

10. Use a special cleaning solution to clean the gel on the surface of the nails, then use a cotton pad to take up the cleaning solution and wipe the nail surface, wash your hands and apply nutrient oil on the nail edges, apply hand cream and massage until absorbed, and finish.

If you feel stinging on your skin after applying phototherapy gel, it may be because the gel has been applied to your nails, or it may be because the gel has been applied too thickly. The dull color of your nails after phototherapy is caused by improper cleaning methods or the failure to use professional cleaning agents during cleaning. The temperature of the gel can be controlled at around 20°C during operation. Too high or too low a temperature may cause brittle cracking. After using the phototherapy pen, you must wipe the brush head of the phototherapy pen clean with a tissue.