How to remove invisible braces What should you pay attention to when removing invisible braces

There are certain requirements for wearing invisible braces, and there are definitely requirements for removing invisible braces. Invisible braces cannot be used for too long. So what is the method to remove invisible braces? Let's take a look below.

1. Starting from the lingual side of the terminal tooth on one side, use your fingertips to slowly dislocate the braces from the tooth.

2. Repeat this process on the opposite side until it is completely dislocated.

3. The fingertips should be slowly moved forward to gently remove the braces from the teeth.

After the braces are removed, the retainer must be worn 24 hours a day for the first six months according to the doctor's instructions. For the second six months, wear it at night. For the third six months, wear it every other night. If the braces are broken or cracked during the process of wearing braces, go to the hospital for a new one in time. In addition, during the period of wearing retainers, go to the hospital for a checkup every 3 months. The doctor will adjust the possible adverse or influencing factors of the teeth in time according to the condition of wearing the retainer to maintain the effect.

Orthodontics, due to the braces, will most likely develop gum recession as a side effect. Dental gold can be used during or after the correction process. Dental gold can allow the atrophied gums to directly absorb enough nutrients when held in the mouth, thereby regenerating the atrophied gums and closing the unsightly gum gaps caused by orthodontics, thus avoiding the side effects of gum recession caused by orthodontics. Improper correction may result in gum recession, loosening, and increased gaps between teeth, so correction should be done with caution.

1. Metal braces, we can see a metal tooth piece glued to the surface of the teeth, that is, steel braces. This situation has a good effect, but the appearance is not so good.

2. Ceramic braces appeared in the 1980s. The small piece glued to the teeth is made of ceramic instead of metal. The aesthetic effect is much better because it is close to the color of the teeth. However, the steel wire used for correction is still metal and can be seen. Therefore, the second type of braces is ceramic braces.

3. Invisible braces. Invisible braces first appeared in the 1970s. Those that are glued inside the teeth are called lingual invisible braces. The braces are glued to the inside of the teeth or the side of the tongue, so they are called lingual braces.

4. A kind of transparent bracketless invisible braces and plastic braces were produced in the late 1990s. It has been more than 20 years since the birth of this brace. It is relatively easy to correct technically, less difficult to correct, and easier for doctors to operate, so it is relatively easy to popularize.